How To Replace Resin In Water Softener. Use needle nose pliers and lift the drain clip to expose the valve drain hose adapter and remove it. Hard water is water that is high in dissolved minerals.
Replacing water softener resin is easy because the process only takes 10 minutes. Connect to bypass, brine line and drain line. Pour in the new resins using a funnel.
The Control Valve Or Head Needs To Be Removed From The Water Softener Treatment Tank.
Water softener resin is a very durable material that in many cases will not have to be replaced in a water softener for the life of the water softener. But there are some circumstances where water softener resin can lose its ability to remove hardness from. How to rebed water softener resin replacement.
Connect To Bypass, Brine Line And Drain Line.
The same procedure applies if you. Unscrew control head by holding tank between your knees and turning the head to the left. This resin uses brine to replace the ions causing hardness like calcium with sodium ions.
Place Tape Over The Opening In The Product Tube.
Replacing water softener resin is easy because the process only takes 10 minutes. Lay softener tank on side, or over trash can. Turn off water rotate the the controller conrol handle to put the softener through its cycles.
Each Resin Bead Is A Type Of Synthetic Plastic That Resembles Polystyrene.
You will hear the air and then the water running to the drain. Pour in the new resins using a funnel. Turn off water, unplug control valve from electric outlet, disconnect control valve from water lines, drain line, and brine line.
This Is A Process That Can Be Done By Yourself In Order To Save Some Money.
Order your resin make sure to buy the correct resin for your tank. It will flow through the water softener resin. In this guide i will go over the exact process on how to remove resin.
Location:
Share :
Post a Comment
for "How To Replace Resin In Water Softener"
Post a Comment for "How To Replace Resin In Water Softener"